Honda outboard alarm codes on the BF115 to BF250 are indicator lights with a buzzer, and the buzzer pattern tells you which one to look at. A beep every second means the charging system or the engine control system has a fault. A continuous buzzer means low oil pressure or overheating, and the engine limits its speed. The meanings below are from Honda's owner's manuals for the BF115J, BF140A and BF150D and for the BF200D, BF225D and BF250D.
Lights and buzzer patterns
| Indicator | Buzzer | Meaning | What Honda says to do |
|---|---|---|---|
| ACG (red) on | One-second intervals | Charging system faulty | The owner's manual lists the ACG fuse under "battery will not charge" |
| Malfunction (red) on | One-second intervals | Engine control system malfunction | The owner's manual gives no owner fix for this one |
| Oil pressure (green) goes out | Continuous | Low oil pressure, engine speed limited | Stop, check the oil level, top up and restart |
| Overheat (red) on | Steady tone | Overheating, speed cut to 1,800 rpm, engine stops after 20 more seconds | Idle in neutral and check the cooling system indicator |
| Water separator | Rapid, repeating | Water in the fuel water separator | Stop the engine and clean the water separator, or consult a dealer |
| None | Three beeps | Battery switch OFF notification (BF115J to BF150D manual) | Turn the battery switch on |
The green oil pressure light works the other way round from the others: lit means the oil pressure is good.
The start-up check
With the ignition switched on, the ACG, malfunction, oil pressure and overheat lights all come on and the buzzer beeps twice. The malfunction, oil pressure and overheat lights go out after the second beep, and the ACG light goes out once the engine starts. The oil pressure light then comes back on and stays on. Honda says a light that doesn't come on during this test can't warn you, so a dealer should check it.
Low oil pressure
Low oil pressure means a low oil level or a problem in the lubrication system. Stop the engine and check the oil, topping it up if it's low. After a restart the oil pressure light should come on within 30 seconds. If the protection stays on after 30 seconds, Honda says to return to the nearest landing and have the motor inspected. Closing the throttle suddenly after full throttle can drop the engine below idle speed and trigger the protection for a moment.
Overheating
Overheating usually comes from blocked water intake screens, or a problem with the thermostat or the water pump. Idle in neutral and look at the cooling system indicator. If water is flowing, keep idling: the overheat light should go out within 30 seconds. If there's no water, stop the engine, tilt the motor up and clean the intake screens. If there's still no water flowing after a restart, return to the landing for an inspection.
For surveyors
On a sea trial, watch the start-up check: all four lights and two beeps. Then confirm a strong stream from the cooling system indicator. Note any light that stays dark, and check the engine against the engine overheating and water pump impeller findings. With Axsail, say "port Honda BF150, overheat light at 4,000 rpm, weak tell-tale stream" and it goes into the engine survey report.