When a boat battery isn't charging, either the charging source has stopped working or the battery can no longer take a charge. A voltmeter at the battery tells you which. A marine electrician quoted in Practical Boat Owner expects 14 volts or more with the engine running and a healthy alternator, against 12.4 to 12.8 at rest. The checks below come from that PBO case and from Optima's battery advice, with the causes Mercury lists in its engine manual.
Read the voltage
| Reading at the battery | What it means, per PBO's electrician |
|---|---|
| 12.4 to 12.8 volts, engine off | Fine at rest |
| 13.6 volts or more | Charging |
| 14 to 14.7 volts | Really good charging |
| Resting voltage with the engine running | The alternator isn't charging |
Take the reading with loads switched off. In PBO's case, the yacht's monitor dropped from 13.4 to 12.7 volts under way, and climbed back once the boat was plugged into shore power, which pointed to the alternator.
Not charging while the engine runs
Mercury lists these for a battery that won't hold charge:
- Battery connections loose or corroded
- Accessory belt worn or stretched
- A defective alternator, including its rectifier and voltage regulator
- Open circuit in the alternator output wire or its fused link
- Heavy use of electrical accessories
- Low electrolyte, or a worn out battery
PBO adds the order a technician followed. Check the belt is tight and turning the alternator. Then the relays and fuses on the engine; the Volvo Penta in PBO's case carries spare fuses in its box. Shake the wiring loom for a loose plug. On engines whose rev counter reads from the alternator, a rev counter falling to zero means the alternator has stopped producing. The electrician confirmed no output with a multimeter and sent the alternator for a bench test. Water in the engine space may have damaged its diodes, which he called very sensitive.
While the alternator is out of action, PBO's electrician says not to let a lead-acid battery fall below 12 volts.
Not charging on shore power
Optima's checks:
- The charger. A broken charger, a blown fuse or a tripped breaker is an often overlooked cause.
- How flat the battery is. Under 10 volts means deeply discharged. Some chargers won't start below a minimum, usually just above 10.5 volts, and may shut off or show a fault code.
- A failed cell. Each cell gives about 2.1 volts. With one dead, the battery may never rise above about 10.5 volts.
- Load test. A battery that reads 10.0 to 10.5 volts after charging, or fails a load test, needs replacing.
See the battery load test and the state of charge tool for reading the numbers.
For surveyors
Record the battery voltage at rest and with the engine at fast idle, both on the starting and house banks, and the charger's state on shore power. With Axsail, say "start battery 12.6 at rest, 12.7 at 1500 rpm, alternator not charging, belt tight" and it goes on the engine survey report.