A Yamaha outboard that won't start is most often in gear, missing the lanyard lock plate, short of fresh fuel, or being started with the wrong choke or throttle setting. Yamaha's owner's manual splits the problem in two, starter won't operate and engine won't start with the starter working, and the checks below follow that chart. The manual used here covers the F9.9C, FT9.9D, F13.5A and F15A; Yamaha says its troubleshooting section covers all its outboards, so some items may not apply to yours.
Starter will not operate
| Yamaha's question | Its remedy |
|---|---|
| Is battery capacity weak or low? | Check the battery; use the recommended capacity |
| Are battery connections loose or corroded? | Tighten the cables and clean the terminals |
| Is the fuse for the electric start relay or circuit blown? | Find the overload, then fit a fuse of the correct rating |
| Are starter components faulty? | Dealer service |
| Is the shift lever in gear? | Shift to neutral |
The small four-strokes carry a 20 amp fuse with a spare in the holder. Yamaha warns against an incorrect fuse or a piece of wire, which risks electrical damage and fire, and says to see a dealer if a new fuse blows straight away.
If the starter itself has failed, the manual gives an emergency rope start for getting back to port. The start-in-gear protection doesn't work on a rope start, so be sure the control is in neutral first.
Engine will not start, starter operates
Work through Yamaha's list:
- Fuel. Tank empty, or fuel stale or contaminated: fill with clean, fresh fuel. Clean or replace a clogged filter.
- Starting procedure. See below; this is the one people skip.
- Spark plugs. Fouled or the wrong type: clean or replace. Check the caps are seated and the ignition wires sound and tight.
- Lanyard. The lock plate must be on the engine stop switch for the engine to run.
- Fuel pump, ignition parts or internal damage. Dealer service.
From the stalling list, two more are easy to miss: the air vent screw on the fuel tank closed, and the choke knob left pulled out.
Starting it the way the manual says
For electric start models with tiller control:
- Gear shift lever in neutral.
- Lanyard attached to you and the lock plate on the stop switch.
- Throttle grip at the start position.
- Choke fully out on a cold engine; it isn't needed warm.
- Press the starter for no more than 5 seconds. If it doesn't fire, wait 10 seconds and try again.
- After 4 or 5 failed tries, open the throttle an eighth to a quarter. Do the same for a warm engine that won't start.
On remote control models with a key, pushing the key in works the choke while it's held, and the 5 second limit is the same.
For surveyors
Note the model and how it started, and whether the cooling tell-tale ran. Report a missing lanyard or spare fuse. With Axsail, say "Yamaha 9.9 tiller, started cold on second pull with full choke, tell-tale good, no lanyard aboard" and it goes on the engine survey report with the finding.