Outboards from different makers fail in the same places. Grouping the published recalls and service campaigns shows where: the shift linkage, the return to idle, cooling, fuel handling, ignition and corrosion. Each section names the engines and links to the page with the detail. On any used outboard, the serial number decides which notices apply.
Shifting
- Honda V6, BF175D to BF250D. The ACCC lists a defect in the shift actuator link rod that may not let the boat shift out of forward gear. See Honda outboard problems.
- Mercury Verado L6. The shift bell crank stud may corrode in seawater and break, losing shift control. See Mercury Verado problems.
- Mercury 3.0 litre FourStroke, 135 to 150 hp. The UK lists upper shift arm studs that can corrode in salt water. See Mercury 150 FourStroke problems.
- On the sea trial. Shift into and out of forward and reverse at idle, several times. Hesitation or a stuck gear is a finding.
Throttle and idle
- Yamaha F200 and F225. Campaign O2003-019: corrosion or dry bushings on the throttle linkage could stop the throttle returning to idle. See Yamaha four-stroke problems.
- Mercury FourStroke 75 to 150 hp, model year 2021. The ACCC lists an out of specification idle air control valve that can keep the revs up, making it hard to shift into neutral.
Cooling
BoatUS says a pump that's blocked or working poorly will overheat the engine, and puts impeller changes at about every other year unless the manual says otherwise. Suzuki's campaign on DF90 to DF140 engines replaced an undersized water pump sleeve that left the engine short of water at idle. Watch the tell-tale stream at idle and at speed. See the outboard water pump impeller finding, and the checks for outboard overheating and an outboard not peeing.
Fuel and ignition
| Engines | Problem | Source |
|---|---|---|
| Honda BF115 to BF250 in a serial range | Vapour separator float can let fuel escape from the air vent tube | ACCC |
| Suzuki DF100A, DF115A, DF140A | Engine control module didn't sound the water in fuel alarm | Suzuki campaign |
| Yamaha VF200 to VF250 V MAX SHO | Ignition coils could be energised with the main switch off | Yamaha recall O2022-002R |
A fuel smell or a sheen on the water round the leg is worth chasing on any outboard. For an engine that won't start at all, work through the outboard won't start checks first. For one that runs but loses power, Mercury's and Yamaha's charts are on outboard losing power.
Corrosion
Yamaha says anodes should be replaced when about half gone and never painted, because they must touch the water. Corrosion in salt water is behind both Mercury shift notices above. See outboard corrosion.
What to check on any used outboard
| Area | What to look for |
|---|---|
| Recall status | Serial number with the maker's dealer, for every engine |
| Shifting | Clean shifts at idle, no stuck gear |
| Idle | Settles back to idle from cruise |
| Cooling | Strong tell-tale stream, impeller service date |
| Fuel | No smell or sheen, water separator clear |
| Corrosion | Anodes under half wasted, linkage and studs under the cowl |
When power trim and tilt stops working, the checks for the motor, relays and fluid are on power trim not working.
Writing it up
"Port outboard: weak tell-tale stream at idle, temperature rising on the sea trial; no record of an impeller change. Recommend the water pump impeller is replaced and the cooling passages flushed before the vessel is next used." Give each engine's make, model and serial number in the particulars, and check each against its maker's recalls.