Ask how long an outboard lasts and you'll hear "about 1,000 hours" on any dock. That number belongs to older engines. The sources below put a modern, serviced outboard well past it, and they agree that corrosion and missed services end more outboards than hours do.
How many hours an outboard lasts
| Engine or use | Hours | Source |
|---|---|---|
| Older outboards, the long-held rule of thumb | About 800 to 1,000 hours | SlashGear, InTheBite |
| Gas marine engine, average recreational use | About 1,500 hours before a lot of work or a rebuild | SlashGear |
| Modern four-stroke, serviced | Thousands of hours | InTheBite |
| Yamaha 150 four-stroke, charter fishing | Almost 6,000 hours, one engine | Power & Motoryacht |
| Engines known to the author | Several over 10,000 hours still in service | InTheBite, the author's own account |
The last two rows are single reports, labelled as such by the writers. They show what's possible on a serviced engine. They don't promise it for the one on the transom.
At BoatTest's figure of about 200 hours a year for a recreational boater, 1,500 hours is seven or eight seasons. A commercial boat can put on that many in under two.
The outboard motor parts diagram shows where each of these sits.
What shortens an outboard's life
- Corrosion. Power & Motoryacht says more engines die from corrosion than from overuse, and that salt water combined with dissimilar metals promotes it most. It suggests replacing anodes when they're half gone and spraying the engine with an anti-corrosion product every month in salt water.
- Overheating. The same article says overheating shortens the life of any engine, and pairs the thermostat with the water pump impeller at service time.
- Fuel. Power & Motoryacht advises never using gas with more than 10 percent ethanol, and warns that moisture in fuel can corrode an outboard's cylinders from inside.
- The wrong job. Capt. Adam Peeples writes that engines failing at moderate hours are usually pushed beyond their intended use, wrongly propped, run incorrectly or poorly maintained.
- Sitting. BRP's Elaine Arsenault told Power & Motoryacht that outboards used more often are known to last longer.
The service intervals that matter
Power & Motoryacht gives lower unit gear oil every 100 hours or at lay-up, notes that some makers, Yamaha among them, suggest the water pump impeller at the same interval, and says some engines get the fuel filter every 100 hours. The engine's own owner's manual sets the interval for the outboard in front of you. Our impeller finding covers the pump.
How a surveyor judges a high-hours outboard
Records first. Peeples says documentation goes a long way in giving buyers confidence in a higher-hours engine. Look for dates and hours for gear oil, impeller, plugs and filters, and check they fit the reading.
The gear oil. Power & Motoryacht says grey lower unit oil points to excessive metal particles, and whitish oil means water in the gearcase.
Compression. The same article recommends a compression check at lay-up. On a used boat, a test across every cylinder is the best single check on the powerhead.
Corrosion. Look at the leg, the clamp brackets, the trim and tilt unit and under the cowl. On saltwater engines this tells you more about remaining life than hours do. See outboard corrosion.
What to check
| Area | What to look for | Source of the concern |
|---|---|---|
| Hour reading | Matches records and the boat's use | BoatTest, InTheBite |
| Gear oil | Grey (metal) or milky (water) | Power & Motoryacht |
| Anodes | More than half gone | Power & Motoryacht |
| Tell-tale and temperatures | Weak stream, overheat history | Power & Motoryacht |
| Compression | Even across cylinders | Power & Motoryacht |
| Fuel | Water separator fitted, ethanol content | Power & Motoryacht |
Writing it up
"Outboard, starboard: hour reading 2,140. Service records show gear oil and impeller at roughly 100 hour intervals to 2,000 hours. Gear oil drained clean. Light corrosion on the clamp bracket, anodes about half consumed. Recommend anodes are replaced and a compression test is carried out across all cylinders before purchase." With Axsail, say the hour reading and what you see on the leg as you photograph it, and the finding is written with its grade.