The Mercury 150 FourStroke is a 3.0 litre four-cylinder outboard sold as the FourStroke, Pro XS and SeaPro. Two published notices cover it, and both go by serial number. For any used 150, the serial number and a Mercury dealer settle what applies and whether it was done.
Model year 2021: idle air control valve
Australia's ACCC lists a recall on model year 2021 Mercury FourStroke 75 to 150 hp engines, Pro XS and SeaPro included. The engines "may have been fitted with an Idle Air Control Valve (IAC) that is out of specification". The engine may then not drop back to idle after running at higher speed. With the revs held up, it can be hard to shift out of gear into neutral, which the ACCC says could cause loss of control, an accident and injury.
| Engines | Serial range |
|---|---|
| 135 to 150 hp | 3B021624 to 3B067243 |
| 75 to 115 hp | 3B034165 to 3B084339 |
Owners were told to stop using the boat and book a Mercury dealer, under Mercury's service bulletin 2021-04R1.
Where to look. The dealer record for the serial number. On the sea trial, bring the engine back from cruise to idle and shift into neutral: it should settle at idle and shift cleanly.
Upper shift arm studs: corrosion in salt water
The UK Office for Product Safety and Standards lists a modification programme for Mercury FourStroke outboards whose upper shift arm studs "can corrode over time" when the motor is used in salt water. The notice says that could lead to loss of shift function if the part fails.
| Engines | Serial range |
|---|---|
| 135 to 150 hp 3.0 litre FourStroke, SeaPro and Pro XS | 1B905505 to 3B625824 |
| 75 to 115 hp 2.1 litre FourStroke, SeaPro and Pro XS | 2B095049 to 3B633935 |
Engines outside the range, or inside it but used only in fresh water, don't need the modification. Owners whose motor has been in salt water are sent to a Mercury dealer.
Where to look. Under the cowl, corrosion on the shift linkage and its studs. Ask whether the engine has been used in salt water, and for the dealer record of the modification.
What to check on a Mercury 150 FourStroke
| Area | What to look for | Source of the concern |
|---|---|---|
| Recall status | Serial number against both ranges; dealer record | ACCC, OPSS |
| Idle and shifting | Returns to idle from cruise; shifts into neutral cleanly | ACCC IAC recall |
| Shift linkage | Corrosion on the upper shift arm studs after salt water use | OPSS 2509-0305 |
| Cooling | Strong tell-tale stream; impeller service record | Outboard impeller |
| Anodes | Less than half wasted, not painted over | Outboard corrosion |
Mercury lists the FourStroke 150 at 455 lb dry; the Mercury outboard weight chart has the rest of the range.
Writing it up
"Outboard, Mercury 150 FourStroke, serial in the range of the UK shift arm stud modification; engine used in salt water; corrosion on the shift linkage under the cowl and no dealer record of the modification. Recommend the serial number is checked with a Mercury dealer and the modification completed before the vessel is next used." Record the serial number in the particulars. For the rest of the Mercury range, see Mercury Verado problems and common outboard problems.