Axsail
VESSEL CODES · AUSTRALIA AND NEW ZEALAND

AMSA survey requirements: certificates of survey and survey frequency for domestic commercial vessels

UPDATED 17 NOVEMBER 2026 · 2 SOURCES

AMSA survey requirements under Marine Order 503: who may survey a domestic commercial vessel, and how often each class is surveyed.

AT A GLANCE
AMSA survey requirements
REGULATOR
AMSA as National Regulator, under the Marine Safety (Domestic Commercial Vessel) National Law and Marine Order 503
APPLIES TO
Australian domestic commercial vessels that need a certificate of survey
SURVEYS AND CERTIFICATE
Initial survey, periodic surveys by frequency category, renewal survey in the 6 months before expiry; certificate valid 5 years unless it says otherwise
GET THE TEXT
Free on the Federal Register of Legislation (Marine Order 503, F2018L00751)

AMSA's survey requirements for domestic commercial vessels are set by Marine Order 503 under the Marine Safety (Domestic Commercial Vessel) National Law. A vessel that needs a certificate of survey has an initial survey, then periodic surveys at a frequency set by its class, and a renewal survey before the certificate runs out at five years. Everything below is from the compiled Marine Order 503 on the Federal Register of Legislation.

Who may survey

Who May survey
AMSA as National Regulator Any vessel
Recognised organisation Any vessel; required from 35 m unless an existing or transitional vessel was surveyed by others before the national system
Accredited marine surveyor The categories of survey they're accredited for, electrical included if accredited
Unrestricted electrical licence holder Electrical surveys other than for plan approval, with a compliance report to the vessel surveyor

Aspects of a vessel built to class rules are surveyed by a recognised organisation at the frequency in the class rules.

Survey frequency

Schedule 3 sets the cycle. Each periodic survey must be done within 3 months before or after the certificate's anniversary in the year it's due.

Frequency Year 0 Year 1 Year 2 Year 3 Year 4 Year 5
High Initial Periodic Periodic Periodic Renewal
Medium Initial Periodic Renewal
Low Initial Renewal

Which category applies depends on the vessel's class, length, whether it carries passengers and whether a modifier applies. Examples from Table 2:

Vessel Frequency
Class 1, or Class 2A, 2B or 2B extended with passengers High
Class 2A, 2B or 2B extended without passengers Medium
Class 2C, 2D with passengers, or 2E with passengers, 12 m and over Medium
Class 2C under 12 m without a modifier Low
Class 3A, 3B or 3B extended Medium
Class 4C, 4D or 4E, 12 m and over or with a modifier Medium
Class 4C, 4D or 4E under 12 m without a modifier Low
Steam propulsion, novel vessels, submersibles, thrill ride vessels High
Permanently moored vessels, unpowered barges Low

Marine Order 503 notes that a vessel with a restricted operational area category has the same frequency as one without the restriction.

Modifiers

A modifier moves a smaller vessel up from low to medium. Marine Order 503 lists:

  • carrying dangerous goods, other than fuel and gas for the vessel's own use
  • an inboard engine running on fuel with a flashpoint below 60°C
  • operating mainly for towage, or supporting the offshore oil or gas industry
  • a Class 4 vessel operated overnight
  • a Category F1 or F2 fast craft, or a landing barge with a stability concern
  • a hull of a material other than aluminium or steel that's at least 15 years old

Certificate, renewal and conditions

  • A certificate without a stated end date ceases 5 years after it came into force.
  • Renewal needs a renewal survey in the 6 months before expiry, and no Schedule 1 change to the vessel. After 2 years without a certificate, the owner applies as if new.
  • After each periodic survey, the owner gives AMSA a report on the vessel's condition and compliance.
  • Defects found at any survey must be fixed, and equipment certificates of currency kept current.
  • A Schedule 1 change means the vessel can't operate until a new certificate is issued.
  • The seller notifies AMSA within 14 days of a change of owner.

For surveyors

An accredited surveyor's report after a periodic survey is what the owner sends AMSA, so it needs the vessel's class, the survey type and every defect with what was done about it. Fibreglass and timber hulls hit the 15 year modifier, so check the build date before quoting the survey frequency. With Axsail, dictate the defects as you go and the report comes out in the order you surveyed, with photos on each item. See how to become a marine surveyor in Australia for accreditation.

Frequently asked

How often does a domestic commercial vessel need a survey in Australia?

Marine Order 503 Schedule 3 sets three survey frequency categories. High-frequency vessels have periodic surveys in years 1, 2 and 3 of the cycle, medium-frequency vessels in year 3, and low-frequency vessels only an initial and a renewal survey. Each periodic survey falls within 3 months either side of the certificate's anniversary.

How long is an AMSA certificate of survey valid?

If the certificate doesn't state an end date, Marine Order 503 says it stops being in force 5 years after it came into force. The renewal survey has to be done within the 6 months before it expires.

Who can survey a domestic commercial vessel?

Marine Order 503 allows AMSA as National Regulator, a recognised organisation, an accredited marine surveyor within the categories they hold, and, for electrical surveys outside plan approval, an unrestricted electrical licence holder. Vessels of 35 m and over go to a recognised organisation unless older arrangements apply.

What is a modifier in AMSA survey frequency?

A circumstance that raises a vessel's survey frequency. Marine Order 503 lists dangerous goods, an inboard engine on fuel with a flashpoint under 60°C, towage, offshore oil and gas support, a Class 4 vessel used overnight, fast craft, and a hull not of aluminium or steel that's at least 15 years old.

Your coding survey report, minutes after the walk-round

Dictate as you inspect. Axsail builds the findings and the report for your signature

Start free

More vessel codes

All vessel codes
UK AND RED ENSIGN

UK small commercial vessel codes

The UK small commercial vessel codes in one place: which boats need one, sport or pleasure versus workboat, the certificate and coding outside the UK.

Read the code
UK AND RED ENSIGN

Workboat Code Edition 3

The MCA Workboat Code Edition 3 for small UK workboats and pilot boats: who it covers, area categories 0 to 6, the examination cycle and the SWB2.

Read the code
UK AND RED ENSIGN

MCA coding

How MCA coding works for a small UK commercial boat: certifying authority, SCV1 or SWB1 application, compliance examination and the SCV2 or SWB2.

Read the code
UK AND RED ENSIGN

REG Yacht Code Part A

The Red Ensign Group Yacht Code Part A for commercial yachts of 24 m and over with up to 12 passengers: its scope and the Short Range Yacht rules.

Read the code
UK AND RED ENSIGN

REG Yacht Code Part B

The Red Ensign Group Yacht Code Part B for passenger yachts with 13 to 36 passengers: scope, PY-1 and PY-2, damage stability and pools on board.

Read the code
UK AND RED ENSIGN

Cayman Islands commercial yachts

What the Cayman Islands Shipping Registry requires before a yacht charters: the code for its length, crew rules and the limits on extra guests at events.

Read the code