The Red Ensign Group Yacht Code Part A is the safety code for large commercial yachts flying a red ensign flag. It applies to motor or sailing yachts of 24 metres load line length and over, in commercial use for sport or pleasure, carrying no cargo and no more than 12 passengers, sail training vessels included. Part B covers yachts carrying 13 to 36 passengers. Everything below is from Part A of the latest edition.
Who stands behind it
The code was developed by the UK, its Crown Dependencies and its Overseas Territories with industry representatives. Each member applies it as the flag Administration; in the UK, it's published with MSN 1895 (M). The preamble says it's an equivalence under the Load Line Convention, SOLAS and STCW, accepted because full convention compliance would be disproportionate for yachts, and that a compliant yacht doesn't need to meet the HSC Code. It's meant for yachts only, never cruise, excursion or ferry operations.
Scope and editions
- Applies to yachts of 24 m load line length and over, up to 12 passengers, no cargo.
- Yacht support or shadow vessels can be certified under it if they carry no cargo beyond spares, tenders and toys for the mother ship.
- A ship converted to a yacht is treated as new from the date the conversion started.
- Yachts already under survey to LY1, LY2, LY3 or the previous revision of Part A may stay under the standards in force at their initial survey.
Short Range Yachts
Requirements assume unrestricted operation outside polar regions. A Short Range Yacht is under 500 GT and restricted to Beaufort force 4 for a motor yacht or force 6 for a sailing yacht, within 60 nautical miles of a safe haven. The Administration can allow set routes up to 90 miles. In exchange, several requirements relax:
| Requirement | Unrestricted yacht | Short Range Yacht |
|---|---|---|
| Liferaft emergency pack | SOLAS A pack | SOLAS B pack |
| Second bilge pump | Fixed, independently powered | May be portable |
| Category A machinery space boundary | A-30 | B-15 |
| Companionway coaming height | 300 mm | 150 mm |
| Damage stability | Required | Recommended where practicable |
Requirements surveyors meet most
- Bilge pumping. At least two fixed, independently powered bilge pumps able to drain any compartment with the yacht heeled to 10 degrees.
- Machinery. Installed to the rules of a Recognised Organisation, with class survey covering at least propulsion, electrical generation and shafting.
- Rig. Rig design reviewed by a Recognised Organisation; from 500 GT, the rig is surveyed during build. Annual surveys review the rig maintenance records against the maintenance manual.
- Stability. A lightweight check every five years unless no major change can be shown.
- Life-saving. Liferafts in GRP containers; lifeboats from 85 metres.
- Security. Yachts of 500 GT and over comply with the ISPS Code.
The certificates to be issued are listed in the code's Annex M, and survey and certification follow Annex N and the Administration's own requirements.
For surveyors
Most work under Part A is done for a Recognised Organisation or the flag Administration, against the yacht's approved plans and its previous survey record. Size and tonnage decide which chapters apply, with A and B versions split at 500 GT, so note both at the start. For a rig survey under the code, the rig survey report template follows the same structure. With Axsail, each item you dictate is kept against the chapter you name, ready for the Administration's report form.