The right outboard size starts with the boat's capacity plate, which states the maximum horsepower. If there's no plate, the US Coast Guard formula in 33 CFR 183.53 gives the figure from the boat's length and transom width. A 15 foot boat with a 5.5 foot transom works out at 45 hp with tiller steering, 75 hp with remote steering, and 30 hp if it's a flat bottom boat. The charts below run the formula for common sizes.
How the formula works
Multiply the length by the transom width, both in feet, to get a factor. Length is measured over the deck from the foremost to the aftermost point, leaving out fittings and the motor. If the transom is narrower than half the beam, use the widest beam in the aftermost quarter of the boat. Up to a factor of 52.5 a table sets the horsepower: 3 hp up to 35, then 5, 7.5, 10 and 15 hp up to 52. Above it:
| Boat | Maximum horsepower |
|---|---|
| Remote steering and a transom at least 20 in high | 2 × factor − 90 |
| Flat bottom, hard chine | 0.5 × factor − 15 |
| Any other boat | 0.8 × factor − 25 |
The result may be raised to the next multiple of 5, which the charts do. Flat bottom, hard chine boats with a factor of 52 or less drop one step in the table.
Tiller steering, vee hull
Maximum horsepower by length (rows) and transom width (columns).
| Length | 4 ft | 4.5 ft | 5 ft | 5.5 ft | 6 ft | 6.5 ft | 7 ft |
|---|---|---|---|---|---|---|---|
| 12 ft | 15 | 20 | 25 | 30 | 35 | 40 | 45 |
| 13 ft | 15 | 25 | 30 | 35 | 40 | 45 | 50 |
| 14 ft | 20 | 30 | 35 | 40 | 45 | 50 | 55 |
| 15 ft | 25 | 30 | 35 | 45 | 50 | 55 | 60 |
| 16 ft | 30 | 35 | 40 | 50 | 55 | 60 | 65 |
| 17 ft | 30 | 40 | 45 | 50 | 60 | 65 | 75 |
| 18 ft | 35 | 40 | 50 | 55 | 65 | 70 | 80 |
| 19 ft | 40 | 45 | 55 | 60 | 70 | 75 | 85 |
Remote steering, transom at least 20 inches
| Length | 4 ft | 4.5 ft | 5 ft | 5.5 ft | 6 ft | 6.5 ft | 7 ft |
|---|---|---|---|---|---|---|---|
| 12 ft | 15 | 20 | 30 | 45 | 55 | 70 | 80 |
| 13 ft | 15 | 30 | 40 | 55 | 70 | 80 | 95 |
| 14 ft | 25 | 40 | 50 | 65 | 80 | 95 | 110 |
| 15 ft | 30 | 45 | 60 | 75 | 90 | 105 | 120 |
| 16 ft | 40 | 55 | 70 | 90 | 105 | 120 | 135 |
| 17 ft | 50 | 65 | 80 | 100 | 115 | 135 | 150 |
| 18 ft | 55 | 75 | 90 | 110 | 130 | 145 | 165 |
| 19 ft | 65 | 85 | 100 | 120 | 140 | 160 | 180 |
Flat bottom, hard chine
| Length | 4 ft | 4.5 ft | 5 ft | 5.5 ft | 6 ft | 6.5 ft | 7 ft |
|---|---|---|---|---|---|---|---|
| 12 ft | 10 | 15 | 15 | 20 | 25 | 25 | 30 |
| 13 ft | 10 | 15 | 20 | 25 | 25 | 30 | 35 |
| 14 ft | 15 | 20 | 20 | 25 | 30 | 35 | 35 |
| 15 ft | 15 | 20 | 25 | 30 | 30 | 35 | 40 |
| 16 ft | 20 | 25 | 25 | 30 | 35 | 40 | 45 |
| 17 ft | 20 | 25 | 30 | 35 | 40 | 45 | 45 |
| 18 ft | 25 | 30 | 30 | 35 | 40 | 45 | 50 |
| 19 ft | 25 | 30 | 35 | 40 | 45 | 50 | 55 |
For exact dimensions, the boat capacity calculator runs the same rule.
Which boats the rule covers
33 CFR 183.51 applies it to monohulls under 20 feet that use outboards, leaving out sailboats, canoes, kayaks and inflatables. Builders of qualifying boats of 13 feet or less can rate horsepower by a performance test instead, so a small boat's plate can read higher than these charts. The engine's weight counts too: a heavier engine at the same horsepower takes more of the plate's weight capacity (see the outboard motor weight chart).
For surveyors
Photograph the plate, record the horsepower fitted, and work out the formula figure if the plate is missing. With Axsail, say "capacity plate 90 hp, fitted Yamaha F115, over the plate rating" and it goes into the engine survey report as a finding.