Axsail
GLOSSARY · HULL AND STRUCTURE

What is a gunwale on a boat? Meaning, pronunciation and the survey check

UPDATED 13 NOVEMBER 2026 · 1 SOURCE

What a gunwale or gunnel is on a boat, where it sits, why the hull-to-deck joint under it matters, and what a surveyor checks along it.

DEFINITION
Gunwale

The top edge of a boat's hull along each side, usually where the deck and hull meet.

ALSO CALLED: GUNNEL

Discover Boating defines the gunwale, also spelled and said "gunnel", as the outermost top edge of the hull, typically where the deck and hull meet.

What a surveyor checks

Because the gunwale usually sits over the hull-to-deck joint, the checks follow the joint: damage along the edge, weeping on the inside of the hull below it, and anything fastened through it. The hull-to-deck joint leak and lifelines and stanchions findings cover what to look for and how to grade it.

In the report

"Port gunwale amidships: rubbing strake split over 400 mm, with damp staining on the hull liner directly below. Recommend the strake is removed and the hull-to-deck joint inspected and resealed." See hull-to-deck joint leak.

Findings to write up

HULL AND STRUCTURE

Hull to deck joint leak

How hull to deck joints are built, where leaks really come from, how a surveyor traces water at the joint, what repair involves and three example findings graded A, B and C.

How to find and write it up
GAS AND SAFETY

Lifelines and stanchions

Why lifelines fail, why plastic-coated wire hides corrosion, how much load a stanchion base takes, what to check on survey, and three example findings graded A, B and C.

How to find and write it up
HULL AND STRUCTURE

Leaking deck hardware

How leaking stanchion bases, cleats and tracks let water into a cored deck, the spider cracks that show poor backing, what Practical Sailor recommends for backing plates, how rebedding works, and three example findings graded A, B and C.

How to find and write it up

Related terms

Glossary
HULL AND STRUCTURE

Hull-to-deck joint

The seam where a fibreglass deck is fastened and sealed to the flange of the hull, usually hidden under the toe rail or rub rail.

HULL AND STRUCTURE

Transom

The flat, aft-facing surface across the stern of a boat, which on many powerboats carries the outboard or sterndrive and, by US rule, the hull identification number.

HULL AND STRUCTURE

Bulkhead

A wall across or along the inside of a boat, bonded to the hull and deck, that stiffens the structure and often carries rig or engine loads.

HULL AND STRUCTURE

Cored hull

A hull or deck built as a sandwich: two skins of fibreglass with a light core of balsa, foam or plywood between them.

HULL AND STRUCTURE

Delamination

Layers of a fibreglass laminate coming apart, or a cored panel's skins separating from the core, which costs the panel its stiffness and strength.

HULL AND STRUCTURE

Gelcoat

The thin, hard, coloured resin layer on the outside of a fibreglass boat, which gives the shiny finish and keeps water off the laminate behind it.

Your full survey report, minutes after the walk-round

Dictate as you inspect. Axsail builds the findings and the report for your signature

Start free