Axsail
FINDINGS LIBRARY · TRAILER

When to replace boat trailer leaf springs and bearings: the checks, the intervals and how surveyors write it up

UPDATED 14 NOVEMBER 2026 · 3 EXAMPLE FINDINGS · 3 SOURCES

When to replace boat trailer leaf springs, how long trailer bearings last between repacks, Dexter's inspection intervals and example findings graded A, B and C.

AT A GLANCE
Worn trailer springs and bearings
USUAL GRADE
A for a cracked or broken spring leaf, or a hub that's hot or leaking grease after a short tow. B for springs flattened or separating, or bearings with no record of service. C for loose shackle bolts or a missing bearing cap
FOUND WITH
Sighting along each spring for cracks and lost arch, checking shackles and bushings for play, feeling the hubs for heat, and looking for thrown grease inside each wheel
JUDGED AGAINST
Dexter's maintenance schedule has springs inspected for wear and loss of arch, and bearings cleaned and repacked, every 12 months or 12,000 miles. Discover Boating recommends repacking every three to five seasons with bearing protectors fitted
REPAIR COST
Springs replaced with their U-bolts and shackles; bearings repacked, or replaced with new seals when pitted or corroded

A trailer's springs and bearings work hardest on the day it's least convenient to fix them: on the ramp, then on the road with the boat on. Both give warnings, and both are quick to check on survey.

When leaf springs need replacing

A cracked leaf or a spring that's lost its arch is finished, and so is one whose leaves have separated, going by Dexter's inspection guide. Its maintenance schedule has springs inspected for wear and loss of arch every 12 months or 12,000 miles, and hanger welds checked at the same interval.

The parts around the spring wear too. Dexter lists:

  • Spring shackles and hangers, with their bolts: looseness or wear
  • Spring eye and equalizer bushings: deterioration
  • Frame hangers: visible cracks, rust trails from fasteners, worn holes or bent parts
  • U-bolt and shackle nuts: tightness to the torque in the axle service manual

Dexter's checklist adds that worn hangers or shackles can cause uneven tyre wear and poor tracking, so a tyre worn on one edge is a reason to look at the springs.

How long trailer bearings last

There's no life in years. Bearings last as long as their grease and seals keep water out, which is the hard part on a boat trailer that's backed into the water.

Job Interval Source
Inspect bearings and cups for corrosion or wear, clean and repack Every 12 months or 12,000 miles Dexter maintenance schedule
Seals Inspect for leakage; replace if removed Dexter maintenance schedule
Hub and drum Inspect for abnormal wear or scoring, every 12 months Dexter maintenance schedule
Repack with fresh grease Every three to five seasons, with bearing protectors fitted Discover Boating
Wheel nuts and bolts Tighten to torque every 3 months or 3,000 miles Dexter maintenance schedule

The two repack intervals differ. Dexter's is for trailers in general. Discover Boating's assumes bearing protectors are fitted. On a trailer that goes into salt water, the shorter one is the safer plan.

Dexter's inspection guide also says hubs should be dry, and any grease or fluid suggests a leak that needs repair. Rust trails under a wheel nut may mean it's loose or has been.

How a surveyor checks it

Get down beside each wheel. Look along each spring for a crack, especially near the eyes, and sight along it for lost arch. Check the shackles and bushings for play and rust trails. Look at the inside of each wheel for thrown grease and at the bearing caps or protectors. If the trailer has just been towed, feel the hubs: one much hotter than the other points at that bearing. Ask for the date of the last bearing service.

What decides the grade

What happens on the next tow. A cracked spring leaf or a leaking, hot hub is an A. Flattened springs, or bearings with no service record on a trailer used in salt water, are a B. Loose fasteners and missing caps are a C.

Worn trailer springs and bearings: example findings

The same defect written up at each grade, the way Axsail writes it from what the surveyor says on board. The grade follows what was found, so use these as wording, then grade what you see.

TRAILERA
Starboard leaf spring, single axle

Main leaf cracked through near the front eye. Spring sitting flat with no arch.

Recommendation: Replace the spring, and its pair on the axle, before the trailer is next towed.

TRAILERB
Both wheel hubs

No record of bearing service. Grease thrown on the inside of the port wheel; seal leaking. Trailer launched in salt water.

Recommendation: Have both hubs stripped, bearings and cups inspected, cleaned and repacked, and seals replaced within 12 months, before any long tow.

TRAILERC
Rear spring shackles

Shackle bolts loose with rust trails. Springs sound.

Recommendation: Tighten the shackle and U-bolt nuts to the axle maker's torque and replace worn bushings at the next service.

ASafety. Safety or compliance deficiency. Fix before the vessel is next underway.
B12 months. Deficiency that needs timely attention. Fix within about 12 months.
CRoutine. Note or observation, cosmetic or maintenance. Routine maintenance at the owner's convenience.

Photos to take

Each spring along its length, any crack close up, the shackles, and the inside of each wheel. With Axsail, say what you see at each wheel as you photograph it and the finding is written with its grade.

Writing it up

Go wheel by wheel: spring condition, shackles and bushings, hub and seal, and the owner's account of the last bearing service, labelled as theirs. Tie the recommendation to the next tow.

Frequently asked

When should boat trailer leaf springs be replaced?

When a leaf cracks or the spring loses its arch, and when its leaves separate, going by Dexter's inspection guide. Its maintenance schedule has springs checked for wear and loss of arch every 12 months or 12,000 miles.

How long do boat trailer bearings last?

They last as long as their grease and seals do. Dexter's schedule has wheel bearings and cups inspected for corrosion or wear, cleaned and repacked every 12 months or 12,000 miles. Discover Boating recommends repacking every three to five seasons, with bearing protectors fitted in between.

How often should boat trailer bearings be repacked?

Dexter says every 12 months or 12,000 miles. Discover Boating gives three to five seasons for a boat trailer with bearing protectors. Use the shorter interval on a trailer that goes into salt water.

What else wears on a trailer suspension?

Dexter lists spring shackles and hangers for looseness or wear, spring eye and equalizer bushings for deterioration, frame hangers for cracks or rust trails at fasteners, and U-bolt and shackle nuts for torque.

Your full survey report, minutes after the walk-round

Dictate as you inspect. Axsail builds the findings and the report for your signature

Start free

Related findings

Findings library
TRAILER

Old trailer tyres

How long boat trailer tyres last, the five and six year age rules from Dexter and the NTSB, how to read the DOT date code and example findings graded A, B and C.

How to find and write it up

Report templates with this finding

FREE TEMPLATE · WORD

Boat trailer inspection

A free boat trailer inspection checklist in Word: tyre type, pressure and age, wheel bearings, brakes, coupler, tongue weight, lights and wiring, frame and lug nuts.

Open template
FREE TEMPLATE · WORD

Pre-purchase survey

Free Word template for a recreational boat or yacht pre-purchase survey report: each section explained, with example wording and findings graded by urgency.

Open template

Related guides

BOAT MAINTENANCE AND COSTS · 3 MIN

Boat haul-out cost: what yards charge per foot to lift, wash, block and launch

What a boat haul-out costs, from yard rate sheets in the US and France: a short haul for a survey, haul, wash, block and launch per foot, and storage.